Publikationen


Suche nach „[B.] [Quandt]“ hat 3 Publikationen gefunden
Suchergebnis als PDF
    DigitalNachhaltigExtern

    Beitrag (Sammelband oder Tagungsband)

    B. Quandt, Korbinian Schröcker, S. Hierl

    Prozessüberwachung beim quasi-simultanen Laser-Durchstrahlschweißen glasfaserverstärkter Thermoplaste

    9. Landshuter Leichtbau-Colloquium (2019), Landshut, vol. 9

    2019

    ISBN: 978-3-9818439-2-7

    DigitalNachhaltigExtern

    Beitrag (Sammelband oder Tagungsband)

    Anton Schmailzl, B. Quandt, S. Hierl, M. Schmidt

    Correlation between Joint Strength and Process Temperature in Quasi-Simultaneous Laser Transmission Welding of Polyamide 6

    Proceedings of LiM2019 - Lasers in Manufacturing (23 June 2019, Munich)

    2019

    DigitalNachhaltigExtern

    Zeitschriftenartikel

    Anton Schmailzl, B. Quandt, M. Schmidt, S. Hierl

    In-Situ process monitoring during laser transmission welding of PA6-GF30

    Procedia CIRP, vol. 74, pp. 524-527

    2018

    DOI: 10.1016/j.procir.2018.08.131

    Abstract anzeigen

    Quasi-simultaneous laser transmission welding is preferably used for packaging sensors and electronics. In order to protect the components from moisture, a hermetic encapsulation is needed. However, local weld seam interruptions cannot be identified with the commonly used set-path monitoring. By using a pyrometer, coaxially integrated into a 3D-scanner, gaps between the joining partners can be allocated on basis of the measured temperature. However, the scattering of the heat radiation, especially caused by the fiber reinforcement of the plastics, leads to a reduction of the accessible heat radiation, which makes the identification of gaps considerably more difficult. The herein used experimental setup is characterized by a small detection spot and only by a slight weakening of the heat radiation inside the scanner. Hence, for welding PA6-GF30, the detection of small sized gaps is possible, even if a glass fiber content of 30 percent (wt.) and a weld seam width with approximately 1 mm are given.